Input connector - One pair of input (Right & Left).
Built-in volume control (does not need a preamp).
Tube:1-6BZ7 (Input) can be substituted with 6N1P, 6922, 6FQ7, 6EV7, 6GU7, 6BQ7, 6CG7 or 6DJ8, 2-807 (Output)
and 1-5U4 (Rectifier) can be substituted with 5Y3, GR34, 274B or 5AR4.
Normal input(R,L), Volume control, Power switch, IEC plug,
Standby switch, Power indicator, Speaker terminals (8 Ohms) and Circuit protection.
All tube signal path, no feedback, switchable between Pentode and Ultra-linear operation.
Power Output: 2.5 watts x2.
WaamampS EL34 SE
Triode/Ultra-Linear
Input connector - Two pair of inputs (switchable, Front/Rear).
Built in volume control and can be used with or without a preamp.
Tubes: 2-El34 , 1-6N1P can be substituted with 6DJ8 / ECC88 / E88CC family of tubes and 1-5U4
can be substituted with 5Y3,GR34 or 5AR4.
Tubes 1-6SL7(Input) can be substituted with 5691 and 2-45 (Output)
can be substituted with 2A3 and 1-5Y3 (Rectifier)
can be substituted with 5U4.
Normal input (R/L), Volume control, Power switch, IEC plug, Power indicator, Speaker terminals (8 Ohms) and Circuit protection.
Circuit Type: Single-Ended Class A. All tube signal path, no feedback (4 Watts)
Dimensions: W 13 1/2" x D 11 1/2" x H 2 1/2"
Amazing Warm Sound
All my amplifiers are 100% HAND-BUILT. Amplifier layouts have been carefully designed using
a combination of vintage and, high quality components. These components are brand new and consist of Hammond
filter choke, Hammond Filament transformers, Heyboer output transformers, Illinois / Cornell-Dubilier electrolytic capacitors,
Auricap capacitors, carbon resistors, IEC plug, gold-plated RCA jacks, speaker jacks, ceramic tube sockets,
ceramic tube caps and power switch. Coupling capacitors are Auricap. Illinois electrolytic capacitors are used in the cathode section and Cornell-Dubilier
electrolytic capacitors are used in the power supply section. Gold plated shielded wire is used in the input stage.
All components are perfectly matched left to right for proper channel balance. Amplifiers are designed on a
garolite board, with all handwired, point to point circuitry using less wire to prevent hum and all grounds are in the
correct places. This design allows this amp to run continuously, with extreme quiet operation. All amplifiers have built
in volume control and can be used with or without a preamp. You can connect any fixed or variable source output
directly to the amplifiers. You can use the audio out from an iPod, CD, DVD, MP3, Computer, XM or SIRUS to the
input connection of these amps. Amplifiers feature normal inputs, volume control, power switch, power indicator,
right/left speaker terminals and circuit protection. They work great into any 4 and 8 ohms speakers.